In the early stages of using cornstarch, wheat straw, and rice straw as primary materials for seasoning, it is recommended to add 5% bran or 4% fermented poultry manure. However, if nitrogen-rich cotton shells are used as the main material, no additional nitrogen source should be added. It's important to monitor for locust infestations during this process. To prevent damage, spraying a diluted solution of dichlorvos or trichlorfon at a 800 times concentration during mixing can be highly effective.
When the pH level is balanced, it's necessary to add 5% lime to the mixture. After each harvest, spray 1% lime water to maintain optimal conditions. Alternatively, you can use 4% gray grass water as an effective substitute.
Ventilation is crucial during the first four days after sowing. Open the vents for about 30 minutes each morning around 10 o'clock. As the mycelium grows and "needles" begin to appear, gradually increase the ventilation time to two hours daily.
If the temperature is low, consider using double-layer film insulation to keep the environment warm. During hot summer months, regular misting and proper scaffolding should be used to cool down the mushroom house and maintain a stable temperature.
When spraying water, especially in moderate weather, it’s best to do so in the morning and evening. Ensure the water temperature is around 30°C to avoid shocking the mushrooms.
The ideal moisture content of the growing medium should be approximately 70%. During the mycelium growth phase, the air humidity should be kept at 80%, while the fruiting bodies require a higher humidity level of around 90% for optimal development.
By following these detailed steps and adjusting based on environmental conditions, you can significantly improve the success rate of your mushroom cultivation. Regular monitoring and timely interventions are key to achieving healthy and productive growth.
ICU Bridge
The cross arm and control cabinet of the tower crane adopt the imported high-strength aluminum alloy ofpatent technology for the one off extrusion molding, ICU bridge and the surface undergoes the primary oxidationtreatment.
Pneumatic brake plus mechanical friction damping brake
The imported electrical machine is adopted, and the electric perpendicular moving up and down.The gas pipeline, power supply and computer communication line are separately arranged withoutinterference.The imported (GENTEC) brand German standard gas terminal (over 20,000 of inserting and pulling out) is adopted.The ICU bridge with high bearing capacity with suspension the cavity mirror car system.The horizontal rotation function can accurately position without excursion.
Icu Bridge,Icu Bridge Pendant,Portable Supply Unit,Tower Crane
Shandong Lewin Medical Equipment Co., Ltd. , https://www.lewinmed.com