1. Iron-proof mechanical parts are rusted: These iron-made mechanical parts should be removed in the winter, cleaned, painted with anti-rust paint, and stored in a ventilated, dry warehouse. Other iron tools such as ploughshares, ploughshares, etc. should be cleaned and painted with a waste oil to prevent rust.
2. Rotten wood-resistant parts: Some agricultural machinery parts are made of wood and are susceptible to mildew after exposure to moisture. Therefore, it should be washed, dried, and coated with tung oil before storage, and then placed in a ventilated and dry place.
3. Aging of anti-rubber parts: V-belts or flat tapes on farm machines such as tractors, pumps, etc. should be removed from the wall or placed in a dry and ventilated place. During parking of the tractor during storage, jacks or bricks shall be used to lift the front and rear axles of the locomotive to lift the tires off the ground and not to bear the load, but care must be taken to maintain proper air pressure.
4. Deformation of anti-spring parts: The clutch of walking tractor is often combined, and the handle should be placed in the “closed†position when it is parked. Otherwise, the clutch spring will be under pressure for a long time and it will lose its elasticity, cause deformation, and be scrapped in advance. . The intake and exhaust valves of the engine should also be placed in a closed state to avoid long-term pressure on the valve spring and to prevent dust from entering the cylinder.
5. Anti-motor damp: The motor on agricultural machinery is not used for a long time and should be placed in a dry, ventilated, clean warehouse. If the motor is placed together with pesticides and fertilizers, or on a damp ground or in a place that is easily exposed to rain, the motor will be exposed to moisture and the internal insulation performance will be reduced, which may cause short circuit, grounding, leakage, and even burn out of coils.
6. Anti-battery vulcanization: Large and medium-sized tractors should be parked for a long time. The battery should be removed. After the electricity is fully charged, the surface should be wiped clean. Vaseline should be painted on the surface of the electric pile, and then placed in a clean and warm room every other month. Perform a recharge to prevent the battery from vulcanizing.
Hammer Grinder,Maize Hammer Mill,Maize Hammer Grinder,Maize Hammer Crusher
HEBEI PINGLE FLOUR MACHINERY GROUP CO., LTD , https://www.plrollermill.com