Advantages 1. The plug valve is used for frequent operation, and the opening and closing is quick and light.
2. The plug valve has low fluid resistance.
3. The plug valve has a simple structure, small relative volume, light weight and easy maintenance.
4, good sealing performance 5, not limited by the installation direction, the flow of the medium can be arbitrary.
6, no vibration, low noise.
Installation and maintenance notes <br> <br> when installing plug valves, plug valves in order to prevent damage, and to ensure full performance plug valves, we should note the following four points:
1. Make sure the valve is open. Heat the pipe first. Transfer as much heat as possible from the pipe to the plug valve. Avoid prolonging the heating time of the plug valve itself.
2. Use gauze or wire brush to remove the pipe and cutting parts to make the metal surface shine. Steel wool is not recommended.
3. First cut the pipe in the vertical direction, trim and remove the burrs, and measure the pipe diameter.
4. Apply flux to the outside of the pipe and the inside of the soldering cover. The flux must completely cover the soldering surface. Please use flux in a controlled manner.
2. The plug valve has low fluid resistance.
3. The plug valve has a simple structure, small relative volume, light weight and easy maintenance.
4, good sealing performance 5, not limited by the installation direction, the flow of the medium can be arbitrary.
6, no vibration, low noise.
Installation and maintenance notes <br> <br> when installing plug valves, plug valves in order to prevent damage, and to ensure full performance plug valves, we should note the following four points:
1. Make sure the valve is open. Heat the pipe first. Transfer as much heat as possible from the pipe to the plug valve. Avoid prolonging the heating time of the plug valve itself.
2. Use gauze or wire brush to remove the pipe and cutting parts to make the metal surface shine. Steel wool is not recommended.
3. First cut the pipe in the vertical direction, trim and remove the burrs, and measure the pipe diameter.
4. Apply flux to the outside of the pipe and the inside of the soldering cover. The flux must completely cover the soldering surface. Please use flux in a controlled manner.
Hebi Tianchi Trading Co., Ltd , https://www.hebitianchi.com