Adjustment and maintenance of cement paste mixer 1. Adjustment of cement paste mixer: The machine has adjusted the gap between the stirring blade and the stirring pot to 2±1mm.
The working gap of the stirring blade and the stirring pot is adjusted, and the adjusting nut (15) can be loosened to rotate the stirring blade to move up and down, and then the detecting rod is used to detect the correct gap, and then the adjusting nut (15) can be tightened. Or loosen the screws connecting the motor and the column (21), the flange of the reduction box (10) and the motor (1), and then tighten the screws.
2, cement paste mixer maintenance: cement paste mixer (1) should keep the work site clean, after each use should thoroughly remove the mixing blade and the residual mortar inside and outside the mixing pot, and clean the mortar and dirty on the scattered and splash machine After the dirt has dried, put on the shield to prevent dust.
(2) The cement paste mixer has no external oil hole. In the transmission case, the moving parts such as the worm gear, the gear and the bearing are added with molybdenum disulfide grease once a quarter. When refueling, the bearing cap can be opened separately, and between the support and the column guide rail, the lubricating mechanism should be dripped frequently between the lifting mechanisms. Maintenance once a year, all the machine is cleaned and greased and greased. Cement paste mixer (3) When the machine is running with metal impact noise, first check whether the gap between the stirring blade and the stirring pot is correct.
(4) When using the stirring pot, it should be handled gently and not randomly, so as not to cause deformation of the stirring pot.
(5) When replacing a new mixing pot or blade, the gap should be adjusted as described above.
(6) The electrical insulation should be checked frequently. The cold insulation resistance ≥5MΩ at 20°C±5°C relative humidity 50%~70%
The working gap of the stirring blade and the stirring pot is adjusted, and the adjusting nut (15) can be loosened to rotate the stirring blade to move up and down, and then the detecting rod is used to detect the correct gap, and then the adjusting nut (15) can be tightened. Or loosen the screws connecting the motor and the column (21), the flange of the reduction box (10) and the motor (1), and then tighten the screws.
2, cement paste mixer maintenance: cement paste mixer (1) should keep the work site clean, after each use should thoroughly remove the mixing blade and the residual mortar inside and outside the mixing pot, and clean the mortar and dirty on the scattered and splash machine After the dirt has dried, put on the shield to prevent dust.
(2) The cement paste mixer has no external oil hole. In the transmission case, the moving parts such as the worm gear, the gear and the bearing are added with molybdenum disulfide grease once a quarter. When refueling, the bearing cap can be opened separately, and between the support and the column guide rail, the lubricating mechanism should be dripped frequently between the lifting mechanisms. Maintenance once a year, all the machine is cleaned and greased and greased. Cement paste mixer (3) When the machine is running with metal impact noise, first check whether the gap between the stirring blade and the stirring pot is correct.
(4) When using the stirring pot, it should be handled gently and not randomly, so as not to cause deformation of the stirring pot.
(5) When replacing a new mixing pot or blade, the gap should be adjusted as described above.
(6) The electrical insulation should be checked frequently. The cold insulation resistance ≥5MΩ at 20°C±5°C relative humidity 50%~70%
Rushan Jinguo Food Co., Ltd , https://www.jinguofood.cn