Good heat conduction oil pump performance and a wide range of advantages to promote the use and promotion of thermal oil pumps used in different environments in the industry applications in different industries Below we explain how to use thermal oil pump properly:
First, after conducting oil pump and piping installed, whether using hydraulic, pneumatic, conducting oil pump inlet and outlet valve must be closed before pressure testing, to prevent damage to the seal, causing leakage.
1 . Boot preparation
1) should be used before starting the HTF delivered filled with thermal oil pump to purge air conducting oil pump, when the valve outlet pipe should be closed.
2) Clean the site , unscrew the bearing housing screws , and add heat transfer oil as lubricant .
3) Handle the coupling pump by hand should be flexible .
4) delivered to the average thermal conductivity of the oil pump is heated before driving, using heat transfer oil is preheated is transported continuously performed by the pump.
Preheating Scale: conducting oil pump housing inlet oil temperature not lower than 40 ℃, preheating speed 50 ℃ / time, warm-up should the pump side of legs nut loosening 0.3-0.5 mm, to be warmed up Tighten .