1. The long-term operation of the crusher should be fixed on the indoor concrete floor. If the work site is frequently changed, the shredder and the electric motor must be installed on a stand made from angle iron. If the crusher is powered by a diesel engine or installed on the body of a small four-wheel tractor, the power of the two should be matched. Even if the diesel engine power is slightly greater than the power of the crusher, the belt grooves of the two must be the same, and the outer end faces of the pulleys are on the same plane. Whether the crusher is designed in the front or rear of the small four-wheeled vehicle, it must be fixed and the protective mesh cover should be provided in the transmission part of the leather. 2. After the crusher is installed, check the tightening conditions of the fasteners. If loose, tighten them. 3. Check whether the tightness of the belt is appropriate and whether the motor shaft and the shredder shaft are parallel. 4. Before the crusher starts, manually turn the pulley or runner to check whether the teeth, hammers and runners are flexible and reliable. There is no collision phenomenon in the shell. Whether the rotation of the wheel is in the direction of the arrows on the machine. Consistent, good body lubrication. 5, do not feel free to replace the pulley to prevent the excessive speed of the crushing room to produce an explosion, or the speed is too low to affect work efficiency. 6. After the crusher starts up, it will idle for 2-3 minutes. After the crusher starts, there is no abnormal phenomenon and it will be used again. 7. Always pay attention to the operation of the pulverizer during work, and feed materials evenly to prevent obstruction of boring cars. Do not overload for a long time. If there is vibration, noise, excessive bearing and body temperature, and external spray, etc., check the machine immediately for stoppage and continue the work after troubleshooting. 8. Check the material carefully before crushing to prevent copper, iron and other hard objects from entering the crushing room and causing accidents and mechanical damage. 9, operators do not wear gloves, feeding should stand on the side of the grinder to prevent rebound debris, granules to hurt the face. 10. It is forbidden to feed or pull feed by hand or wooden stick when jamming. After the power is cut off, the materials fed into the room are cleared and the work is performed.
Black Goji Berry,Goji Berry Extract ,Goji Powder ,Goji Berry Powder
Dried Fruit Co., Ltd. , http://www.nbgojihome.com